Raptor 190 FPV Quadcopter Carbon Plates Kit

Stylish, aggressive lines, fully enclosed electronics for a sleek look and aerodynamic advantage.

The Raptor 190 was designed from the ground up with inspiration from the look and style of the Sigan Drone, Fossils Gravity 250 and Walkera Runner 250 quads.  Ultimately I went for a Hawk-like appearance with ventilation holes to simulate feathers.  

• Carbon Fiber upper and lower plates for maximum durability; 3k twill, 2.5mm, matte finish
• Center spacer / Camera Plate 3D print STL files. 

***STL File pack will be emailed separately following purchase.  Please allow up to 24 hours for them to be sent; if you're waiting longer than that then send an email with Order Number and Name***

Build instructions and recommended Hardware:
Coming Soon

What you get:

• Upper and Lower plates in 2.5mm 3K Twill Carbon Fiber.
• all necessary bolts/nuts for building the frame + Allan key.
• antenna tubes x2 to clear the props.
• Battery strap
• 1x set of 4x4.5 Bullnose DALProps

What you'll need:

• Pliers or small wrench
• Several Zip Ties or Double Sided Tape
• Soldering skills and patience!
• 3D Printer to make your own Spacer

Recommended Hardware (as seen on my prototype):

• Taranis X9D Plus 
• CC3D Atom
• FrSky D4R-II
• ELGAE FPV200 Camera/Transmitter Combo
• Fatshark Dominator V3
• ZTW Spider Series 18A OPTO Multi-Rotor ESC
• Scorpion M-2204-2300KV motors
• Turnigy Graphene 1300mAh 3S
• Suitable Antennas